| FLOOR
SUPPORTS |
 |
| MS Type floor
supports are available with a wide range of adjustment. Specify top
of belt or roller elevation. One support required at every bed joint
and ends of conveyor. Holes in feet for lagging to floor. Knee braces
recommended above MS-6 support. |
| CONVEYING
SPEED |
|
| Other constant
and variable speeds from 30 to 120 FPM. Over 120 FPM timing belt drive
recommended. Capacity affected with speed change.
|
| CROSSOVER |
|
| Separate section
relocates drive shaft from one side of conveyor to the other. Minimum
Elevation-12-3/8 in. |
| GUARD
RAILS |
|
| Continuous
adjustable channel, fixed channel or type A & B angle. NOTE:
If product comes in contact with guard rails, product flow
will be affected. Fixed channel overlapping, one direction.
Fixed channel non-overlapping, reversing. |
|
| POLY-TIER
SUPPORTS |
|
| 36 in. to
120 in. support heights in 6 in. increments. Knee braces supplied.
|
| CEILING
HANGERS |
|
| 5/8 in. dia.
x 8 ft. long unplated rods fully threaded. Other lengths and galvanized
rods available. |
| MOTORS |
|
| Energy efficient,
single phase, other characteristics. 2 HP maximum. |
| ELECTRICAL
CONTROLS |
|
| Non-reversing
or reversible magnetic starters and push-button stations. AC variable
frequency drive. |
|
